SIMPLE & FAST LED LIGHT BAR SETUP INSTRUCTIONS TABLE TOP MOUNT & FLOOR STAND MOUNT. READ BEFORE USING & WATCH THE QUICK SETUP VIDEOS INCLUDED.
Typical Assembly Setup install would an “L” or a “U” shape configuration.
Step #1
TABLE TOP MODEL: Place (1) corner base plate (4) inches from the front edge of the booth & (4) inches from the side. FLOOR STAND MODEL: Place under your floor model display case.
Step #2
TABLE TOP MODEL: Place additional base plates every (6) to (8) feet depending on the length of your lights. You must clamp to table or keep at least (1) pound of weight on the base plates at all times to prevent them from falling.
FLOOR STAND MODEL: Please keep weight on the base plates by making sure they are tucked under your floor model display cases.
Step #3
Slide(do not twist or force) the support poles on to the base plate peg. Make sure the power outlets are facing the inside of the booth & drape the power cord over the back edge of the table.
Step #4
Use the optional stabilizer suction clips to clamp the poles to any glass surface for additional stability. This is best used with the floor stand models.
Step #5
Use the (2) pieces of light bars and slide them together making sure not to twist or force together. Insert the locking pin.
Step #6
Rest both ends of the light bar on their appropriate clips on top of the heads. Align the power cord with outlet & plug each end into the outlets. Sometimes you may need to locate a stand a foot or so from the end of the light: in this case you will need a 1ft. extension cord for the plug to reach. Make sure the bar is seated firmly in the clips. Run power to the stands electrical cord & turn the lights on.
Step #7
Walk around your booth and adjust the angle of the lights to center onto your display by rotating the lights. Your trade show lighting is sure to look professional and beautiful with Show Off Lighting LED trade show lights.
PLEASE BE SURE TO WATCH THIS SETUP VIDEO WHICH COVERS BOTH THE TABLE TOP & FLOOR MODELS
BULBS:
You can safely use almost any GU10 base bulb, up to 50 watts in each socket.We do not use halogen or high heat producing bulbs in our trade show lighting. Our standard shipping configuration is with low heat warm and cool COB LED bulbs.
LIGHT BAR JOINTS:
With the lock pin, always slide the lights together, do not twist. Twisting the light bars will cause the precision machined parts to scrape and chip, which will cause them to stick. Always keep very light grease on the fittings to prevent this. If light bars start sticking, wipe the connectors inside and out. Use a fine sandpaper (1000 grit) to clean the pin and the socket and re-apply a light lube, Vaseline will work just fine.
HEAT:
Remember our standard bulb configuration does not ship with any halogens or high heat producing bulbs only low heat COB LED bulbs.
REPLACEMENT BULBS:
Due to the portable nature of Show Off Lighting, occasionally bulbs will go bad. Bouncing and banging the lights will decrease the bulbs lifespan. Using these guidelines will ensure the maximum life from your bulb investment.
BULB WARRANTY:
Show Off Lighting ships with (2) advanced warranty replacement matched spare bulbs for each light bar purchased. Bulbs will fail occasionally and you now have spares on hand to keep matched bulbs shining bright. Matching bulbs will always be available from Show Off Lighting for a reasonable price.
LED LIGHT BAR & POP UP LIGHT WARRANTY (INCLUDING BULBS):
Show Off Lighting is guaranteed for (2) years from manufacturing defects. If there is a defect we will fix it at no charge. Simply return the light to our Denver, North Carolina facility. Accidental damage can be repaired quickly and easily by contacting us. Warranty excludes bulbs.